Palm Blade Ceiling Fan Black With Wood Blades

Be sure that energy is current by checking the swap and the fuse field. You are able to do this pretty simply by turning off the facility to the fan circuit and unscrewing the screws that maintain the swap the electrical field. You may want a voltage tester (accessible from a ironmongery store or dwelling heart) to test the screw terminals to ensure that they don’t seem to be charged after which you may pull the swap from the field itself.

Set up the hanger pipe – Place the hanger pipe within the gap on the highest of the fan motor. Slowly draw out the wires from the middle. Tighten the set-screws supplied with the fan. Connect the blades – Connect the fan blades to the principle physique. Customary fan blades include a two-pronged attachment. Join the screws by way of the holes current on the blades to the flanges. Tighten them utilizing a screwdriver.


The mounting bracket is the a part of your ceiling fan that holds it to the ceiling, and failure of this half is extraordinarily unlikely. Nevertheless, water harm or loss throughout a transfer can happen, an the mounting bracket can simply get replaced. In case your ceiling fan makes use of a downrod, you can exchange the mounting bracket at nearly any ironmongery store or dwelling heart. In case you have a unique association, you have to to get involved with the producer.

Wire the fan – Decide the new and customary wires by coloration: black is sizzling for the fan, blue is sizzling for the sunshine equipment, white is frequent for the fan and lightweight equipment, and inexperienced is floor. In all instances, ensure that all uncovered wiring is secured inside wire nuts. Wires should be linked in such a means that the black home wires are linked to the black ceiling fan wires whereas the white home wires are linked to the white fan wires. The usual colours for grounding wires are both naked copper or inexperienced. You must wire-nut the bottom wires from the field to these from the facility provide and the fan. As soon as wiring is full, gently push wires into the electrical field.