Nickel Finish Ceiling Fan With Light Automation

Decide what measurement fan you want. If the size of the room that you may be putting in the fan in are not any larger than 12’ in any course (size or width), then you must use a 36” fan. If the biggest dimension of the room is between 12’ and 15’, then you must use a 42” fan. If the biggest dimension of the room is larger than 15’, then you must use not less than a 52” fan.

Set up the hanger pipe – Place the hanger pipe within the gap on the highest of the fan motor. Slowly draw out the wires from the middle. Tighten the set-screws supplied with the fan. Connect the blades – Connect the fan blades to the principle physique. Customary fan blades include a two-pronged attachment. Join the screws by way of the holes current on the blades to the flanges. Tighten them utilizing a screwdriver.


After you unscrew the wires from the terminals, straighten the ends of the wire with needle-nosed pliers earlier than you twist the 2 ends collectively and screw a wire nut over the twisted wires. Flip the circuit again on and see if the fan works. If it does, the swap is dangerous and you must exchange it. If there’s nonetheless no exercise, you have to a specialist to test the wiring and the fixture.

The motor, as the facility supply, may be the a part of the fan that’s the most tough to switch. Motors lately are are constructed to final, although, and it’s thought-about a reasonably uncommon downside if it’s the motor itself that fails. Alternative may be needed if the motor fails, though in case you are connected to the ceiling fan itself, you may all the time test with a specialist.