Ceiling Fan Rotates Wrong Direction With Light 3 Way Switch

Set up the hanger pipe – Place the hanger pipe within the gap on the highest of the fan motor. Slowly draw out the wires from the middle. Tighten the set-screws supplied with the fan. Connect the blades – Connect the fan blades to the principle physique. Customary fan blades include a two-pronged attachment. Join the screws by way of the holes current on the blades to the flanges. Tighten them utilizing a screwdriver.

Earlier than you start putting in your ceiling fan, make sure that the facility to the fixture is off. Double test this with a high-voltage neon tester if doable. Lock the breaker field to ensure nobody unintentionally turns the facility again on when you are putting in the fan. Ensure you have any needed permits, if relevant. Just be sure you have sufficient room for a fan.


As earlier than, use a voltage tester after you take away the faceplate and swap to ensure that the wires are secure to the touch and disconnect the wires from the swap. Per the instructions on the anti-hum fan management, twist the wires current collectively and after including the wire nuts, exchange the management and faceplate earlier than restoring the facility.

Set up the hanger bracket – Set up the hanger bracket utilizing lock washers and screws. Lock washers ought to be supplied with the fan but when they don’t seem to be part of the set up equipment then buy them from a ironmongery store. Lock washers will stop the screws from loosening when the fan vibrates.