Large Flush Ceiling Lights Artemis Fan

Set up the hanger pipe – Place the hanger pipe within the gap on the highest of the fan motor. Slowly draw out the wires from the middle. Tighten the set-screws supplied with the fan. Connect the blades – Connect the fan blades to the principle physique. Customary fan blades include a two-pronged attachment. Join the screws by way of the holes current on the blades to the flanges. Tighten them utilizing a screwdriver.

This how-to consists of primary directions for putting in a ceiling fan. Bear in mind, nonetheless, to all the time seek the advice of the producer’s directions throughout precise set up. Since ceiling followers are most frequently used to switch current lighting fixtures, the wiring to the fan ought to already be full. Set up will not be tough, and solely requires that you just take note of the directions included with the fan. If extra wiring have to be performed to put in your fan and you aren’t accustomed to wiring, seek the advice of knowledgeable electrician. All wiring should conform to native and nationwide codes.


Earlier than you start putting in your ceiling fan, make sure that the facility to the fixture is off. Double test this with a high-voltage neon tester if doable. Lock the breaker field to ensure nobody unintentionally turns the facility again on when you are putting in the fan. Ensure you have any needed permits, if relevant. Just be sure you have sufficient room for a fan.

The motor, as the facility supply, may be the a part of the fan that’s the most tough to switch. Motors lately are are constructed to final, although, and it’s thought-about a reasonably uncommon downside if it’s the motor itself that fails. Alternative may be needed if the motor fails, though in case you are connected to the ceiling fan itself, you may all the time test with a specialist.