Black Pendant Light Fitting Hunter Fan Remote Reverse Direction

Followers ought to be mounted at least 7’ from the ground and 12” from the ceiling. 18” from the ceiling is preferable for extra air circulate. Followers have to be mounted not less than 24” from any obstructions. An acceptable junction or outlet field securely connected to the constructing construction is required. Substitute the outdated field with one labeled as accepted for ceiling followers or ceiling suspended ”paddle” fan set up. The field and its assist should be capable of assist the transferring weight of the fan. Use the set up hardware beneficial by the junction field producer. Followers of over 35 kilos, with or with out equipment, require extra assist unbiased of the outlet field. Verify with knowledgeable about your native constructing codes.

This how-to consists of primary directions for putting in a ceiling fan. Bear in mind, nonetheless, to all the time seek the advice of the producer’s directions throughout precise set up. Since ceiling followers are most frequently used to switch current lighting fixtures, the wiring to the fan ought to already be full. Set up will not be tough, and solely requires that you just take note of the directions included with the fan. If extra wiring have to be performed to put in your fan and you aren’t accustomed to wiring, seek the advice of knowledgeable electrician. All wiring should conform to native and nationwide codes.


Ceiling followers are aesthetically pleasing, helpful and vitality environment friendly. Whereas most individuals know that followers can present a cool breeze in the summertime, many do not notice that a fan may also be used to power heat air down from the ceiling within the winter. Mild kits may even be added to extend the usefulness of many ceiling followers.

As a result of a fan makes use of nearly the identical quantity of energy as a ceiling fixture, the electrical circuit will not be overloaded. In case your fan consists of lights, be certain the circuit it is on has sufficient capability to deal with the extra load. If not, you need to run a brand new circuit with a brand new circuit breaker from the home’s principal service panel or sub-panel to the fan. If there isn’t a central mild fixture, you may need to create a spot to hold the ceiling fan. Then, you may must carry electrical energy to it. You may faucet into an current circuit to do that.