Canarm Fan Control Craftmade Winton Ceiling

The mounting bracket is the a part of your ceiling fan that holds it to the ceiling, and failure of this half is extraordinarily unlikely. Nevertheless, water harm or loss throughout a transfer can happen, an the mounting bracket can simply get replaced. In case your ceiling fan makes use of a downrod, you can exchange the mounting bracket at nearly any ironmongery store or dwelling heart. In case you have a unique association, you have to to get involved with the producer.

Set up the hanger pipe – Place the hanger pipe within the gap on the highest of the fan motor. Slowly draw out the wires from the middle. Tighten the set-screws supplied with the fan. Connect the blades – Connect the fan blades to the principle physique. Customary fan blades include a two-pronged attachment. Join the screws by way of the holes current on the blades to the flanges. Tighten them utilizing a screwdriver.


Wire the fan – Decide the new and customary wires by coloration: black is sizzling for the fan, blue is sizzling for the sunshine equipment, white is frequent for the fan and lightweight equipment, and inexperienced is floor. In all instances, ensure that all uncovered wiring is secured inside wire nuts. Wires should be linked in such a means that the black home wires are linked to the black ceiling fan wires whereas the white home wires are linked to the white fan wires. The usual colours for grounding wires are both naked copper or inexperienced. You must wire-nut the bottom wires from the field to these from the facility provide and the fan. As soon as wiring is full, gently push wires into the electrical field.

After you unscrew the wires from the terminals, straighten the ends of the wire with needle-nosed pliers earlier than you twist the 2 ends collectively and screw a wire nut over the twisted wires. Flip the circuit again on and see if the fan works. If it does, the swap is dangerous and you must exchange it. If there’s nonetheless no exercise, you have to a specialist to test the wiring and the fixture.