Ceiling Fan Repair Service Lowes Installation

As a result of a fan makes use of nearly the identical quantity of energy as a ceiling fixture, the electrical circuit will not be overloaded. In case your fan consists of lights, be certain the circuit it is on has sufficient capability to deal with the extra load. If not, you need to run a brand new circuit with a brand new circuit breaker from the home’s principal service panel or sub-panel to the fan. If there isn’t a central mild fixture, you may need to create a spot to hold the ceiling fan. Then, you may must carry electrical energy to it. You may faucet into an current circuit to do that.

Verify to ensure that your fan has been put in right into a specifically designed ceiling electrical field that’s made for followers, as an everyday one that’s meant just for lights will likely be unable to assist the fan’s fixed motion and weight. If the fan put in into the mistaken form of electrical field, you have to a specialist or an electrician.


Earlier than unscrewing the entire fixture, nonetheless, tighten all screws by hand. In case you have a droprod concerned in supporting your fan, ensure that the ball joint on the prime of the drop rod is well-settled with the assist bracket. Equally, ensure that the blade ideas grasp an equal distance from the ceiling; if the blades are warped, a wobble might end result. If so, you may name the producer for blade replacements or head to your native dwelling heart.

This how-to consists of primary directions for putting in a ceiling fan. Bear in mind, nonetheless, to all the time seek the advice of the producer’s directions throughout precise set up. Since ceiling followers are most frequently used to switch current lighting fixtures, the wiring to the fan ought to already be full. Set up will not be tough, and solely requires that you just take note of the directions included with the fan. If extra wiring have to be performed to put in your fan and you aren’t accustomed to wiring, seek the advice of knowledgeable electrician. All wiring should conform to native and nationwide codes.