Ceiling Fan Rubber Grommets Hunter Universal Wall Mount Control

Set up the hanger pipe – Place the hanger pipe within the gap on the highest of the fan motor. Slowly draw out the wires from the middle. Tighten the set-screws supplied with the fan. Connect the blades – Connect the fan blades to the principle physique. Customary fan blades include a two-pronged attachment. Join the screws by way of the holes current on the blades to the flanges. Tighten them utilizing a screwdriver.

The motor, as the facility supply, may be the a part of the fan that’s the most tough to switch. Motors lately are are constructed to final, although, and it’s thought-about a reasonably uncommon downside if it’s the motor itself that fails. Alternative may be needed if the motor fails, though in case you are connected to the ceiling fan itself, you may all the time test with a specialist.


After you unscrew the wires from the terminals, straighten the ends of the wire with needle-nosed pliers earlier than you twist the 2 ends collectively and screw a wire nut over the twisted wires. Flip the circuit again on and see if the fan works. If it does, the swap is dangerous and you must exchange it. If there’s nonetheless no exercise, you have to a specialist to test the wiring and the fixture.

Pullchain switches are the most typical a part of a ceiling fan to require restore, probably as a consequence of the truth that they’re the half that’s most frequently dealt with. You may discover that the chain will be pulled out of the socket if yanked too exhausting, however fortunately they’re simply taken care of.