Ceiling Fan Three Wire Connection Hugger With Light And Remote

Be sure that energy is current by checking the swap and the fuse field. You are able to do this pretty simply by turning off the facility to the fan circuit and unscrewing the screws that maintain the swap the electrical field. You may want a voltage tester (accessible from a ironmongery store or dwelling heart) to test the screw terminals to ensure that they don’t seem to be charged after which you may pull the swap from the field itself.

This how-to consists of primary directions for putting in a ceiling fan. Bear in mind, nonetheless, to all the time seek the advice of the producer’s directions throughout precise set up. Since ceiling followers are most frequently used to switch current lighting fixtures, the wiring to the fan ought to already be full. Set up will not be tough, and solely requires that you just take note of the directions included with the fan. If extra wiring have to be performed to put in your fan and you aren’t accustomed to wiring, seek the advice of knowledgeable electrician. All wiring should conform to native and nationwide codes.


As earlier than, use a voltage tester after you take away the faceplate and swap to ensure that the wires are secure to the touch and disconnect the wires from the swap. Per the instructions on the anti-hum fan management, twist the wires current collectively and after including the wire nuts, exchange the management and faceplate earlier than restoring the facility.

Verify to ensure that your fan has been put in right into a specifically designed ceiling electrical field that’s made for followers, as an everyday one that’s meant just for lights will likely be unable to assist the fan’s fixed motion and weight. If the fan put in into the mistaken form of electrical field, you have to a specialist or an electrician.