Fan On Slanted Ceiling Hunter Bennett Edison

Ceiling followers not solely present reasonably priced cooling, additionally they add worth to your house if and while you ever resolve to promote. And inside this reasonably in depth market, Harbor Breeze ceiling followers actually stand out by way of worth, décor and long-term reliability. You may simply test them out on-line, or at any Lowes retailer the place they’re retailed solely and backed by Lowes’ in addition to the producer, Litex.

Followers ought to be mounted at least 7’ from the ground and 12” from the ceiling. 18” from the ceiling is preferable for extra air circulate. Followers have to be mounted not less than 24” from any obstructions. An acceptable junction or outlet field securely connected to the constructing construction is required. Substitute the outdated field with one labeled as accepted for ceiling followers or ceiling suspended ”paddle” fan set up. The field and its assist should be capable of assist the transferring weight of the fan. Use the set up hardware beneficial by the junction field producer. Followers of over 35 kilos, with or with out equipment, require extra assist unbiased of the outlet field. Verify with knowledgeable about your native constructing codes.


This how-to consists of primary directions for putting in a ceiling fan. Bear in mind, nonetheless, to all the time seek the advice of the producer’s directions throughout precise set up. Since ceiling followers are most frequently used to switch current lighting fixtures, the wiring to the fan ought to already be full. Set up will not be tough, and solely requires that you just take note of the directions included with the fan. If extra wiring have to be performed to put in your fan and you aren’t accustomed to wiring, seek the advice of knowledgeable electrician. All wiring should conform to native and nationwide codes.

As earlier than, use a voltage tester after you take away the faceplate and swap to ensure that the wires are secure to the touch and disconnect the wires from the swap. Per the instructions on the anti-hum fan management, twist the wires current collectively and after including the wire nuts, exchange the management and faceplate earlier than restoring the facility.