Fanco Ceiling Fan Remote Control Top Ten Company

Followers ought to be mounted at least 7’ from the ground and 12” from the ceiling. 18” from the ceiling is preferable for extra air circulate. Followers have to be mounted not less than 24” from any obstructions. An acceptable junction or outlet field securely connected to the constructing construction is required. Substitute the outdated field with one labeled as accepted for ceiling followers or ceiling suspended ”paddle” fan set up. The field and its assist should be capable of assist the transferring weight of the fan. Use the set up hardware beneficial by the junction field producer. Followers of over 35 kilos, with or with out equipment, require extra assist unbiased of the outlet field. Verify with knowledgeable about your native constructing codes.

The motor, as the facility supply, may be the a part of the fan that’s the most tough to switch. Motors lately are are constructed to final, although, and it’s thought-about a reasonably uncommon downside if it’s the motor itself that fails. Alternative may be needed if the motor fails, though in case you are connected to the ceiling fan itself, you may all the time test with a specialist.


The mounting bracket is the a part of your ceiling fan that holds it to the ceiling, and failure of this half is extraordinarily unlikely. Nevertheless, water harm or loss throughout a transfer can happen, an the mounting bracket can simply get replaced. In case your ceiling fan makes use of a downrod, you can exchange the mounting bracket at nearly any ironmongery store or dwelling heart. In case you have a unique association, you have to to get involved with the producer.

Set up the hanger pipe – Place the hanger pipe within the gap on the highest of the fan motor. Slowly draw out the wires from the middle. Tighten the set-screws supplied with the fan. Connect the blades – Connect the fan blades to the principle physique. Customary fan blades include a two-pronged attachment. Join the screws by way of the holes current on the blades to the flanges. Tighten them utilizing a screwdriver.