Hinkley Regency Fans Exhaust For Bathrooms At Home Depot

Followers ought to be mounted at least 7’ from the ground and 12” from the ceiling. 18” from the ceiling is preferable for extra air circulate. Followers have to be mounted not less than 24” from any obstructions. An acceptable junction or outlet field securely connected to the constructing construction is required. Substitute the outdated field with one labeled as accepted for ceiling followers or ceiling suspended ”paddle” fan set up. The field and its assist should be capable of assist the transferring weight of the fan. Use the set up hardware beneficial by the junction field producer. Followers of over 35 kilos, with or with out equipment, require extra assist unbiased of the outlet field. Verify with knowledgeable about your native constructing codes.

This how-to consists of primary directions for putting in a ceiling fan. Bear in mind, nonetheless, to all the time seek the advice of the producer’s directions throughout precise set up. Since ceiling followers are most frequently used to switch current lighting fixtures, the wiring to the fan ought to already be full. Set up will not be tough, and solely requires that you just take note of the directions included with the fan. If extra wiring have to be performed to put in your fan and you aren’t accustomed to wiring, seek the advice of knowledgeable electrician. All wiring should conform to native and nationwide codes.


The absolute best approach to know the precise measurement of a room that may accommodate any sort of Westinghouse fan is to measure the room itself. As an example a 35 inches Westinghouse ceiling fan will simply work effectively in an 8×12 foot room whereas a 52 inch ceiling fan could be wanted for an 18×20 foot room. Shopping for any Westinghouse ceiling fan comes with a restricted lifetime Warranties, 10 12 months restricted Guarantee and 25 years restricted warranties.

Set up the hanger bracket – Set up the hanger bracket utilizing lock washers and screws. Lock washers ought to be supplied with the fan but when they don’t seem to be part of the set up equipment then buy them from a ironmongery store. Lock washers will stop the screws from loosening when the fan vibrates.