Low Consumption Ceiling Fan With Crystal Light Fixture

Earlier than you start putting in your ceiling fan, make sure that the facility to the fixture is off. Double test this with a high-voltage neon tester if doable. Lock the breaker field to ensure nobody unintentionally turns the facility again on when you are putting in the fan. Ensure you have any needed permits, if relevant. Just be sure you have sufficient room for a fan.

After you unscrew the wires from the terminals, straighten the ends of the wire with needle-nosed pliers earlier than you twist the 2 ends collectively and screw a wire nut over the twisted wires. Flip the circuit again on and see if the fan works. If it does, the swap is dangerous and you must exchange it. If there’s nonetheless no exercise, you have to a specialist to test the wiring and the fixture.


This how-to consists of primary directions for putting in a ceiling fan. Bear in mind, nonetheless, to all the time seek the advice of the producer’s directions throughout precise set up. Since ceiling followers are most frequently used to switch current lighting fixtures, the wiring to the fan ought to already be full. Set up will not be tough, and solely requires that you just take note of the directions included with the fan. If extra wiring have to be performed to put in your fan and you aren’t accustomed to wiring, seek the advice of knowledgeable electrician. All wiring should conform to native and nationwide codes.

You may test by unscrewing and reducing the fan’s housing the ceiling; you can see a label that may designate it as being fan-rated. U-bolts or lag screws ought to join the field to a bracket or a strong wooden block for stability.