Model Uc7225t Fan Remote Hunter Outdoor Ceiling Fans

Earlier than you start putting in your ceiling fan, make sure that the facility to the fixture is off. Double test this with a high-voltage neon tester if doable. Lock the breaker field to ensure nobody unintentionally turns the facility again on when you are putting in the fan. Ensure you have any needed permits, if relevant. Just be sure you have sufficient room for a fan.

Be sure that energy is current by checking the swap and the fuse field. You are able to do this pretty simply by turning off the facility to the fan circuit and unscrewing the screws that maintain the swap the electrical field. You may want a voltage tester (accessible from a ironmongery store or dwelling heart) to test the screw terminals to ensure that they don’t seem to be charged after which you may pull the swap from the field itself.


Followers ought to be mounted at least 7’ from the ground and 12” from the ceiling. 18” from the ceiling is preferable for extra air circulate. Followers have to be mounted not less than 24” from any obstructions. An acceptable junction or outlet field securely connected to the constructing construction is required. Substitute the outdated field with one labeled as accepted for ceiling followers or ceiling suspended ”paddle” fan set up. The field and its assist should be capable of assist the transferring weight of the fan. Use the set up hardware beneficial by the junction field producer. Followers of over 35 kilos, with or with out equipment, require extra assist unbiased of the outlet field. Verify with knowledgeable about your native constructing codes.

Wire the fan – Decide the new and customary wires by coloration: black is sizzling for the fan, blue is sizzling for the sunshine equipment, white is frequent for the fan and lightweight equipment, and inexperienced is floor. In all instances, ensure that all uncovered wiring is secured inside wire nuts. Wires should be linked in such a means that the black home wires are linked to the black ceiling fan wires whereas the white home wires are linked to the white fan wires. The usual colours for grounding wires are both naked copper or inexperienced. You must wire-nut the bottom wires from the field to these from the facility provide and the fan. As soon as wiring is full, gently push wires into the electrical field.