Panasonic Whisper Ceiling Fan Hunter Kensington

Earlier than you start putting in your ceiling fan, make sure that the facility to the fixture is off. Double test this with a high-voltage neon tester if doable. Lock the breaker field to ensure nobody unintentionally turns the facility again on when you are putting in the fan. Ensure you have any needed permits, if relevant. Just be sure you have sufficient room for a fan.

After you unscrew the wires from the terminals, straighten the ends of the wire with needle-nosed pliers earlier than you twist the 2 ends collectively and screw a wire nut over the twisted wires. Flip the circuit again on and see if the fan works. If it does, the swap is dangerous and you must exchange it. If there’s nonetheless no exercise, you have to a specialist to test the wiring and the fixture.


Set up the hanger pipe – Place the hanger pipe within the gap on the highest of the fan motor. Slowly draw out the wires from the middle. Tighten the set-screws supplied with the fan. Connect the blades – Connect the fan blades to the principle physique. Customary fan blades include a two-pronged attachment. Join the screws by way of the holes current on the blades to the flanges. Tighten them utilizing a screwdriver.

Followers ought to be mounted at least 7’ from the ground and 12” from the ceiling. 18” from the ceiling is preferable for extra air circulate. Followers have to be mounted not less than 24” from any obstructions. An acceptable junction or outlet field securely connected to the constructing construction is required. Substitute the outdated field with one labeled as accepted for ceiling followers or ceiling suspended ”paddle” fan set up. The field and its assist should be capable of assist the transferring weight of the fan. Use the set up hardware beneficial by the junction field producer. Followers of over 35 kilos, with or with out equipment, require extra assist unbiased of the outlet field. Verify with knowledgeable about your native constructing codes.