Spyda 56 Ceiling Fan Which Way Should The Spin For Summer

Followers ought to be mounted at least 7’ from the ground and 12” from the ceiling. 18” from the ceiling is preferable for extra air circulate. Followers have to be mounted not less than 24” from any obstructions. An acceptable junction or outlet field securely connected to the constructing construction is required. Substitute the outdated field with one labeled as accepted for ceiling followers or ceiling suspended ”paddle” fan set up. The field and its assist should be capable of assist the transferring weight of the fan. Use the set up hardware beneficial by the junction field producer. Followers of over 35 kilos, with or with out equipment, require extra assist unbiased of the outlet field. Verify with knowledgeable about your native constructing codes.

You may test by unscrewing and reducing the fan’s housing the ceiling; you can see a label that may designate it as being fan-rated. U-bolts or lag screws ought to join the field to a bracket or a strong wooden block for stability.


As a result of a fan makes use of nearly the identical quantity of energy as a ceiling fixture, the electrical circuit will not be overloaded. In case your fan consists of lights, be certain the circuit it is on has sufficient capability to deal with the extra load. If not, you need to run a brand new circuit with a brand new circuit breaker from the home’s principal service panel or sub-panel to the fan. If there isn’t a central mild fixture, you may need to create a spot to hold the ceiling fan. Then, you may must carry electrical energy to it. You may faucet into an current circuit to do that.

Set up the hanger pipe – Place the hanger pipe within the gap on the highest of the fan motor. Slowly draw out the wires from the middle. Tighten the set-screws supplied with the fan. Connect the blades – Connect the fan blades to the principle physique. Customary fan blades include a two-pronged attachment. Join the screws by way of the holes current on the blades to the flanges. Tighten them utilizing a screwdriver.