80 Inch Ceiling Fan With Light Low Profile Brushed Nickel

After you unscrew the wires from the terminals, straighten the ends of the wire with needle-nosed pliers earlier than you twist the 2 ends collectively and screw a wire nut over the twisted wires. Flip the circuit again on and see if the fan works. If it does, the swap is dangerous and you must exchange it. If there’s nonetheless no exercise, you have to a specialist to test the wiring and the fixture.

Set up the hanger bracket – Set up the hanger bracket utilizing lock washers and screws. Lock washers ought to be supplied with the fan but when they don’t seem to be part of the set up equipment then buy them from a ironmongery store. Lock washers will stop the screws from loosening when the fan vibrates.


The mounting bracket is the a part of your ceiling fan that holds it to the ceiling, and failure of this half is extraordinarily unlikely. Nevertheless, water harm or loss throughout a transfer can happen, an the mounting bracket can simply get replaced. In case your ceiling fan makes use of a downrod, you can exchange the mounting bracket at nearly any ironmongery store or dwelling heart. In case you have a unique association, you have to to get involved with the producer.

Be sure that energy is current by checking the swap and the fuse field. You are able to do this pretty simply by turning off the facility to the fan circuit and unscrewing the screws that maintain the swap the electrical field. You may want a voltage tester (accessible from a ironmongery store or dwelling heart) to test the screw terminals to ensure that they don’t seem to be charged after which you may pull the swap from the field itself.