Ceiling Fan Light Diffuser Replacement 42 Inch Blades

Set up the hanger bracket – Set up the hanger bracket utilizing lock washers and screws. Lock washers ought to be supplied with the fan but when they don’t seem to be part of the set up equipment then buy them from a ironmongery store. Lock washers will stop the screws from loosening when the fan vibrates.

Decide what measurement fan you want. If the size of the room that you may be putting in the fan in are not any larger than 12’ in any course (size or width), then you must use a 36” fan. If the biggest dimension of the room is between 12’ and 15’, then you must use a 42” fan. If the biggest dimension of the room is larger than 15’, then you must use not less than a 52” fan.


After you unscrew the wires from the terminals, straighten the ends of the wire with needle-nosed pliers earlier than you twist the 2 ends collectively and screw a wire nut over the twisted wires. Flip the circuit again on and see if the fan works. If it does, the swap is dangerous and you must exchange it. If there’s nonetheless no exercise, you have to a specialist to test the wiring and the fixture.

As earlier than, use a voltage tester after you take away the faceplate and swap to ensure that the wires are secure to the touch and disconnect the wires from the swap. Per the instructions on the anti-hum fan management, twist the wires current collectively and after including the wire nuts, exchange the management and faceplate earlier than restoring the facility.